This is an old revision of the document!
1.1.2 G101
G101
set which axes should be interpolated. The P
parameter is a bitmask where bit 1 represents X axis, bit 2 Y axis, ….
Bitmask value is stored in variable number #5120
.
en:software:mdurosettacncsoftwaregcode:supported_g_m-codes:g101
This is an old revision of the document!
G101
set which axes should be interpolated. The P
parameter is a bitmask where bit 1 represents X axis, bit 2 Y axis, ….
Bitmask value is stored in variable number #5120
.