Differenze

Queste sono le differenze tra la revisione selezionata e la versione attuale della pagina.

Link a questa pagina di confronto

Entrambe le parti precedenti la revisione Revisione precedente
software:mdurosettacncsoftware [2020/01/08 15:17]
cnc205 [7.3.2 Z position after M18]
software:mdurosettacncsoftware [2020/01/10 09:07] (versione attuale)
cnc205 [7.3 Operation]
Linea 747: Linea 747:
 When CNC is in Plasma Mode: When CNC is in Plasma Mode:
  
-  * ''​M3'' ​active ​the Plasma Torch output.\\ +  * ''​M3'' ​actives ​the Plasma Torch output.\\ 
-  * ''​M4''/''​M5'' ​deactive ​the Plasma Torch output.\\+  * ''​M4''/''​M5'' ​deactives ​the Plasma Torch output.\\
   * ''​M17''​ enables the THC device control of Z axis height.\\   * ''​M17''​ enables the THC device control of Z axis height.\\
-  * ''​M18'' ​disabled ​the THC device control of Z axis height.\\+  * ''​M18'' ​disables ​the THC device control of Z axis height.\\
  
 The ''​M17''​ instruction activates the Z axis control by THC. When this instruction is encountered,​ RosettaCNC saves the current Z axis position, then disconnects the axis from the interpolation and commands it via the Up torch and Down torch inputs. When the instruction ''​M18''​ is met RosettaCNC maintains the current position up to a new command Z instruction inside the G-code. During the THC check, a digital output, if configured, is activated to manage any external electromechanical logic. The ''​M17''​ instruction activates the Z axis control by THC. When this instruction is encountered,​ RosettaCNC saves the current Z axis position, then disconnects the axis from the interpolation and commands it via the Up torch and Down torch inputs. When the instruction ''​M18''​ is met RosettaCNC maintains the current position up to a new command Z instruction inside the G-code. During the THC check, a digital output, if configured, is activated to manage any external electromechanical logic.
  • Ultima modifica: 2020/01/10 09:07
  • da cnc205